Checking clutch lining of torque converter clutch: VW Phaeton

🧭 Before you start

Fits: VW Phaeton (3D)

• Special tools named: torque wrench
• Renewed: torque converter, atf lines

Don't miss

• Use 1/4” to 1/2” adapter.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Insert torque converter adapter T10284 into splines of torque converter.
2. Apply torque wrench with 3 ... 23 Nm scale (commercially available) to adapter. [Note: Use 1/4” to 1/2” adapter.] — 23 Nm (17 lb-ft)
3. Turn torque wrench in (direction of arrow) while a second mechanic holds torque converter.
4. Renew torque converter.
5. Dismantle complete gearbox and clean all parts, and renew ATF lines.
6. Dismantle and check all clutches.
7. Renew torque converter (cannot be cleaned).
8. Renew valve body (cannot be cleaned).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Vehicles with hydraulic belt tensioning system · 6 torque figures
• Removing, installing and tensioning toothed belts · 5 torque figures
• 5-speed automatic gearbox 09A — Assembling gearbox · 5 torque figures
• Removing and installing camshaft adjuster (vehicles from 11/2008) · 7 torque figures
• Tensioning toothed belt · 9 torque figures