Removing and installing starterB, 1.6 l TDI engine, 77 kW, manual gearbox MQ250-6F — VW

🧭 Before you start

Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)

📋 Procedure

1. Disconnect battery .
2. Remove air filter housing 23Air filter; Removing and installing air filter housing.
3. Push protective cap off solenoid switch downwards in direction of (arrow).
4. Undo nut (1) and detach positive wire from connection thread of solenoid switch.
5. Release connector of terminal 50 (2) and separate.

6. Unscrew securing nut (arrow) and take earth wire off upper securing bolt of starter.
7. Remove upper securing bolt of starter (arrow).
8. Remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
9. Undo nut (1) from lower securing bolt of starter.
10. Remove wire holder (2).
11. Undo lower starter bolt (arrow).
12. Remove starter by taking it downwards out of the vehicle.
13. Tighten threaded connections to specified torque given in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Rear seat belt lower fastening point ("“4-door”" Gol/Voyage) - remove and install · 1 torque figures
• Rear seat belt lower fastening point (Saveiro "“double cab”" ) - remove and install · 1 torque figures
• Speed sensor on rear axle (vehicles with drum brake) - remove and install · 1 torque figures
• Thermostat valve (large circuit) - remove and install
• Rear seat belts "“with automatic belt retractor”" (Spacefox/Suran) - remove and install · 1 torque figures