Removing and installing starter, vehicles with double clutch gearbox, DQ250-6F — VW

🧭 Before you start

Fits: platform codes AU1, BX5

📋 Procedure

1. Disconnect batteryA.
2. If necessary, remove air filter housing 23Air filter; Removing and installing air filter housing or 24Air filter; Removing and installing air filter housing.
3. Remove noise insulation General body repairs, exterior66Noise insulation; Assembly overview - noise insulation.
4. Unscrew nut (2) from lower bolt for starterB(1).
5. Remove earth cable (3).

6. Unscrew bolt (4) for starterB(1).
7. Release connector (3) and disconnect.
8. Press off cap (4).
9. Unscrew nut (5) and remove terminal 30/B+.
10. Remove bolt (1) for starterB(2).
11. Remove starterB(2) upwards.
12. Reconnect batteryA.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing battery, petrol engine models with battery in luggage compartment · 2 torque figures
• Installing engine (Tiguan) – VW 1.4 · 1 torque figures
• Installing gearbox, Jetta 2011
• Removing and installing pump-valve unit, RHD vehicles – VW · 2 torque figures
• Removing and installing pressure plate/drive plate – VW · 3 torque figures