Removing and installing starter, vehicles with 2.0 l TSI engine and manual gearbox MQ500 — VW

🧭 Before you start

Fits: VW Tiguan I (5N, 2007–2016)

Don't miss

• When batteries are disconnected and reconnected, the procedure described in the workshop manual must be strictly observed . — Disconnect battery .

📋 Procedure

1. ⚠ When batteries are disconnected and reconnected, the procedure described in the workshop manual must be strictly observed . — Disconnect battery .
2. Release and disconnect connector (1) and release spring-type clip (2) using spring type clip pliersVAS 5024A.
3. Release locking lugs (arrows) and take off cover.
4. Pull off hose (arrow) from air filter housing and remove from vehicle.
5. Remove securing bolt from air filter housing (arrow).

6. Pull air filter housing upwards out of its rubber mountings and remove from vehicle.
7. Slide protective cap (1) off solenoid switch in direction of (arrow).
8. Release and disconnect terminal 50 connector (1).
9. Unscrew nut (2) and remove positive lead (3) from solenoid switch.
10. Remove upper securing nut (1) of wiring retainer (2).
11. Remove noise insulation General body repairs, exterior50Body - front; Noise insulation.
12. Unscrew lower securing nut (2) and remove wiring retainer (1) from securing bolts of starter.
13. Remove upper securing bolt of starter (arrow).
14. Remove lower securing bolt of starter (arrow).
15. Remove starter downwards out of vehicle.
16. Tighten threaded connections to torques specified in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing valve timing housing – VW Jetta VI · 2 torque figures
• Removing and installing suspension strut, suspension strut for adaptive chassis control DCC · 1 torque figures
• Removing and installing compressor housing and turbine housing · 3 torque figures
• Removing and installing valve stem seals (cylinder head installed) · 1 torque figures
• Checking holding pressure, vehicles with engine codes CWVA, CWVB, CHYA, CHYB