Removing and installing starter, vehicles with 2.0 l TDI engine, 103 kW, manual gearbox MQ350 — VW

🧭 Before you start

Fits: platform code 1F8

📋 Procedure

1. Disconnect battery .
2. Remove air filter housing Engine mixture preparation23Diesel direct injection system; Removing and installing air filter.
3. Push protective cap off solenoid switch downwards in direction of (arrow).
4. Release connector of terminal 50 (2) and separate.
5. Unscrew securing nut (1) and remove underlying positive cable from connecting thread of solenoid switch.

6. Unscrew nut (arrow) from upper securing bolt of starter and remove underlying earth cable.
7. Remove upper securing bolt of starter (arrow).
8. Remove noise insulation General body repairs, exterior50Body front; Noise insulation.
9. Unscrew securing nut (1) and remove cable retainer from lower securing bolt of starter.
10. Remove lower securing bolt of starter (arrow).
11. Remove starter from vehicle.
12. Tighten threaded connections to torque specified in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• New Bettle 1.8 Turbo AWU AWV camshaft chain
• VW Eos 1F 2.0 TFSi camshaft BWA timing chain replacement
• Code letters, gearbox allocation, ratios, capacities
• Removing and installing tandem pump · 4 torque figures
• Removing and installing engine control unit – VW Jetta VI · 3 torque figures