Removing and installing starter, 2.0 l, 125 kW TDI engine with manual gearbox MQ350-6F — VW

🧭 Before you start

Fits: VW Golf VI (5K, 2008–2013)

📋 Procedure

1. Disconnect battery .
2. Remove the air filter housing Engine mixture preparation23Diesel direct injection system; Removing and installing air filter.
3. Slide protective cap in direction of (arrow) off solenoid switch.
4. Unscrew positive wire (1) and disconnect connector from terminal 50 (2).
5. Remove securing bolt of starter (arrow).

6. Remove noise insulation General body repairs, exterior50Body - front; Noise insulation.
7. Remove securing nut (1) from lower securing bolt of starter.
8. Remove wiring retainer (2).
9. Remove lower securing bolt of starter (arrow).
10. Remove starter from vehicle.
11. Tighten threaded connections to torques specified in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing intake manifold flap motor V157 and intake manifold flap potentiometer G336
• Removing and installing starter, vehicles with dual clutch gearbox (DQ250-6F)
• Removing and installing dash panel insertKX2 – VW
• Removing and installing fog light bulb L22/L23
• Adjusting installation position of tail light – VW