Removing and installing speed sensor on front axle: VW Passat B5
Step-by-step removing and installing speed sensor on front axle for the VW Passat B5: 15 steps, 4 torque figures.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B5 (3B)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Insert speed sensor into hole in wheel bearing housing and tighten bolt |
| 8 Nm (5.9 lb-ft) | Fit sensor to wheel bearing housing fitting hole and tighten bolt |
| 8 Nm (5.9 lb-ft) | Insert speed sensor into hole in wheel bearing housing and tighten bolt |
| 8 Nm (5.9 lb-ft) | Insert speed sensor into wheel bearing housing hole and tighten bolt |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Loosen wheel bolts.
- Raise vehicle.
- Remove wheel.
- Release grommet (1) in wheel housing.
- Separate speed sensor line connection (2).
- Unclip speed sensor line from retainers (arrows).
- For vehicles with brake wear indicator separate the connector (1).
- Lift up locking tab slightly on connector lower part (2) and then turn by 90° degrees.
- Pull connector lower part out of bracket.
- Pull ABS speed sensor out of wheel bearing housing.
- Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with lubricating paste G 000 650.
- Install ABS speed sensor
- Clip speed sensor line into retainers and insert grommet into wheel housing.
- Insert brake wear indicator connector into bracket on brake caliper.
- Turn steering to left and right lock and check clearance to speed sensor line.
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.