Removing and installing speed sensor on rear axle (drum brakes) — VW
Removing and installing speed sensor on rear axle (drum brakes) on VW: 7 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6R (2009–2014)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 8 Nm (5.9 lb-ft) | Fit sensor to wheel bearing housing fitting hole and tighten bolt |
| 8 Nm (5.9 lb-ft) | Insert speed sensor into hole in stub axle and tighten bolt |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Raise vehicle.
- Separate connector (1) from speed sensor wire and from speed sensor.
- Remove bolt (2) from stub axle.
- Pull ABS speed sensor out of stub axle.
- Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with high-temperature paste G 052 112 A3.
- Insert speed sensor into hole in stub axle and tighten bolt to 8 Nm. — 8 Nm (5.9 lb-ft)
- Connect speed sensor to speed sensor wire.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Checking function – VW Golf IV / Bora
- Dismantling and assembling heater unit · 1 torque figures
- Removing bevel box, Tiguan with 2.0 l petrol engine
- Renewing stub shaft oil seals with bevel box removed
- Renewing front drink holder, vehicles without centre armrest
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.