Removing and installing side trim — VW
Removing and installing side trim on VW: 12 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 9C1, 1C1, 1Y7
- Renewed: as necessary
Don't miss
- Before installing trim (3), check clips (5) and (6) and renew as necessary.Install Bowden cable so that there is no play.After installing trim ensure door inner seal is seated correctly.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 3 Nm (2.2 lb-ft) | Remove the two bolts (2 |
| 3.5 Nm (2.6 lb-ft) | Unscrew bolt (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove bench seat and backrest Seat frame72Rear seats.
- Remove bolt (9) or nut (10).
- Pull trim (3) off in vicinity of clips (5) and (6) and take out carefully upwards.
- Guide front seat belt (1) and rear seat belt (7) through.
- Disconnect connector (1) of control motor (2).
- Remove electrical connections (5) from loudspeaker (6).
- Unclip Bowden cable (3) from ball head pin (1).
- Prise off spring clips (2) and remove Bowden cable (3) from retaining plate (4).
- Remove anchorage point for front seat belt Front passenger airbag, seat belts69Assembly overview - front seat belt with belt tensioner (Cabriolet).
- Disconnect cover (2) and guide seat belt (1) through opening.
- Remove anchorage point for rear seat belt Front passenger airbag, seat belts69Assembly overview - rear seat belt (Cabriolet).
- Disconnect cover (8) and guide seat belt (7) through opening. [Note: Before installing trim (3), check clips (5) and (6) and renew as necessary.Install Bowden cable so that there is no play.After installing trim ensure door inner seal is seated correctly.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Adjusting clutch engagement mechanism – VW Jetta VI
- Removing and installing control unit and hydraulic unit, diesel engine
- Removing gearbox, Golf Plus 2005
- Removing and installing high-pressure pump - engine code CAVD · 2 torque figures
- Adjusting sliding/tilting sunroof glass panel (height adjustment) · 2 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.