Removing and installing side airbag with rear side airbag igniter N201/N202 — VW

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018); platform code AV2

Don't miss

• The bolts are microencapsulated and must be renewed each time they are removed.Before new bolts are installed, the threads of the corresponding holes must be cleaned.
• Ensure electrical connector is pushed fully onto stop and engages audibly.Ensure that no cables are trapped.
• If airbag warning lamp K75 indicates a fault following installation, event memory must be read, deleted and then read again .

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. ⚠ Follow safety regulations for pyrotechnic components .Also observe the additional safety regulations for the side airbag .Follow disposal regulations for pyrotechnic components . — Remove side padding together with side airbag (1).
2. Release connector (2) together with wiring harness from side padding (1).
3. Unscrew bolts (3) (9 Nm). [Note: The bolts are microencapsulated and must be renewed each time they are removed.Before new bolts are installed, the threads of the corresponding holes must be cleaned.] — 9 Nm (6.6 lb-ft)
4. Remove rear side airbag (4) from side padding (1).
5. ⚠ Follow safety regulations for pyrotechnic components .Before handling pyrotechnic components (e.g. connecting the electrical connector), the person handling them must ensure that he/she is "“electrically discharged”". To do this e.g. briefly touch the door striker plate. — Install in reverse order of removal. [Note: Ensure electrical connector is pushed fully onto stop and engages audibly.Ensure that no cables are trapped.]
6. ⚠ Battery must be connected with ignition switched on. If pyrotechnic components (e.g. airbag, seat belt tensioners) are repaired incorrectly, undesired triggering may occur after the battery is connected. Ensure that nobody is in vehicle when connecting battery. — Connect battery earth cable with ignition switched on Electrical system27Battery; Connecting and disconnecting battery. [Note: If airbag warning lamp K75 indicates a fault following installation, event memory must be read, deleted and then read again .]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing guide plate
• Assembly overview - differential
• Removing and installing (right-hand drive models) voltage stabiliser J532 · 1 torque figures
• Repairing upper inner retaining tab – VW Tiguan I · 1 torque figures
• Removing and installing engine control unit J623, Sharan and Tiguan