Removing and installing side airbag crash sensor on driver side G179 (4-door models) — VW
Removing and installing side airbag crash sensor on driver side G179 (4-door models) on VW: 7 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6R (2009–2014)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1 Nm (0.7 lb-ft) | Remove bolts (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- ⚠ Observe the general safety regulations when working on airbag, belt tensioner and battery isolator units (pyrotechnic components) — Disconnect vehicle battery Electrical system 27. Disconnecting and reconnecting battery.
- Removing door trim (see the separate procedure).
- Release connector locking mechanism and pull off connector (2) from side airbag crash sensor on driver side G179(1)(arrow).
- Remove bolts (3) (1 Nm). — 1 Nm (0.7 lb-ft)
- Install in reverse order of removal.
- Switch ignition on.
- ⚠ Ensure that nobody is in vehicle. — Reconnect vehicle battery Electrical system 27. Disconnecting and reconnecting battery.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing poly V-belt pulley with a freewheel, manufacturer: Bosch
- Removing and installing alternator, 1.4 l 59 kW injection engine with air conditioning system
- Removing front belt end fitting (4-door, Sedan) · 1 torque figures
- Removing and installing poly V-belt pulley with a freewheel
- Removing subframe
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.