Removing and installing sender 2 for turbocharger speed G689 — VW

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

• Timing position: the crankshaft or camshaft is set and locked during this job

🔧 Engine codes this applies to

📋 Procedure

1. Remove engine cover .
2. Unscrew bolts (arrows) and push bracket (1) together with wiring harness to one side.
3. Remove electrical connectors (1, 2, 3) from bracket and push to one side.
4. Siphon off refrigerant of the air-conditioning system 87.
5. Remove securing nut (5).

6. Unscrew bolts (1) and (4) and remove refrigerant line (2).
7. Unscrew bolts (arrows) and remove cover (1).
8. Turn locking pins (arrows) 180° and pull out upwards.
9. Pull intake connecting pipe (A) out of the upper section of the air filter.
10. Open clips and remove upper part of air filter (B).
11. Disconnect electrical connector (3) and remove bolt (1).
12. Release hose clips (2) and (5) and remove air pipes (left-side).
13. Disconnect electrical connector (arrow).
14. Remove bolts (1) and (3), and remove sender 2 for turbocharger speed G689 with bracket.
15. Unscrew bolts (2) and remove engine speed sensor from bracket.
16. Fit refrigerant line (2) and screw in bolts (1) and (4) by hand.
17. Position clip (3).
18. Fill air conditioning system 87.

Other VW procedures

• Removing and installing fuel pressure regulating valve N276 · 1 torque figures
• Removing and installing engine mounting – VW
• Removing and installing pressure differential sender G505 or pressure differential sender 2G524
• Assembly overview - exhaust manifold · 1 torque figures
• Removing and installing turbocharger on left – VW Touareg II
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures