Removing and installing seals on assembly frame: VW Passat CC / CC
Step-by-step removing and installing seals on assembly frame for the VW Passat CC / CC: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat CC (357, 2008–2012), VW CC (358, 2012–2017)
Don't miss
- Bonding surface must be free of dust and grease.
📋 Procedure
- Remove assembly frame for panorama tilting sunroof .
- Pull off damaged seal.
- Remove remaining adhesive residues with adhesive strip removerVAS 6349.
- Rub off bonding surface using commercially available steel wool.
- Bonding surface must be free of dust and grease.
- Clean complete bonding surface with cleaning solutionD 009 401 04.
- Gradually pull protective backing off adhesive tape on new seal and press on seal.
- If the seal is excessively long, any excess length is evenly compressed.
- Press on seal evenly and all round twice using roller3356.
- Install assembly frame for panorama tilting sunroof .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing seat longitudinal adjustment · 5 torque figures
- Removing and installing particulate filter · 3 torque figures
- Removing, installing and tensioning toothed belt, engine code AJH · 3 torque figures
- Vehicles with 2.0 l FSI engine and manual gearbox · 5 torque figures
- Removing and installing fuel tank (Autogas) – VW Polo 6R 1.4 · 6 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.