Removing and installing seal on gearbox side — VW

🧭 Before you start

Fits: platform codes 1C1, 1Y7

• Timing position: the crankshaft or camshaft is set and locked during this job
• Special tools named: T10122/1, T10122/2, puller

Don't miss

• Do not additionally oil or grease the oil seal sealing lip.
• Clean sealing surfaces. They must be free of oil and grease.

🔧 Engine codes this applies to

📋 Procedure

1. Remove gearbox.
2. Lock crankshaft .
3. Remove flywheel and drive plate and take off sender wheel for engine speed sender G28 from crankshaft.
4. Pull out oil seal using puller hooks T20143/2. [Note: Do not additionally oil or grease the oil seal sealing lip.]
5. Clean sealing surfaces. They must be free of oil and grease.

6. Remove oil residue from crankshaft journal using clean cloth.
7. Fit assembly aid T10122/1 onto assembly sleeve T10122/2 and slide oil seal (A) onto assembly sleeve.
8. Take off assembly aid T10122/1.
9. Fit assembly sleeve T10122/2 with oil seal (A) on crankshaft.
10. Press in oil seal uniformly until flush all round using press sleeve T10122/3.

Other VW procedures

• Removing and installing fuel delivery unit, fuel gauge sender · 2 torque figures
• Removing and installing fuel filter – VW Touran II · 3 torque figures
• Removing and installing valve timing housing – VW Jetta VI · 2 torque figures
• Removing engine - Jetta from MY 2011
• Removing and installing intake manifold – VW Touareg I
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures