Removing and installing rear shelf: VW Jetta VI
Step-by-step removing and installing rear shelf for the VW Jetta VI: 12 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Jetta VI (16, 2010–2018); platform code AV2
- Renewed: if necessary
Don't miss
- Before installing, check all fasteners for damage and renew if necessary.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 40 Nm (30 lb-ft) | Unscrew and remove bolt (1) on each side |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove left and right C-pillar trim .
- Remove belt end anchor for rear outer seat belt on left and right.
- Unscrew and remove bolt (1) on each side (40 Nm). — 40 Nm (30 lb-ft)
- Remove belt end anchor (2) from fastening buckle (3) on both sides
- Remove retaining clips (3).
- Unclip retaining clips (2). To do this, pull front area of rear shelf (1) upwards in (direction of arrow).
- Pull rear shelf (4) in direction of travel (arrow A) until guide pins (1) emerge from guides in body (arrow B).
- Detach connector (3) of bulb for high-level brake light M25(2).
- Take outer left and right belt end anchors out of side belt guides of rear shelf.
- Take middle seat belt out of cut-out (arrow C) of rear shelf.
- Remove rear shelf (4) from vehicle.
- Install in reverse order of removal. [Note: Before installing, check all fasteners for damage and renew if necessary.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Dismantling and assembling parts of intake manifold – VW AGP
- Checking injection timing regulation range – VW 1.9 SDI
- Adjusting pedal position sender
- Repairing cover for Torsen differential, removing and installing Torsen differential
- Removing and installing fuel tank with attachments and fuel filter: engine code AJH
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.