Removing and installing rear outer three-point seat belt, 2-door models — VW

🧭 Before you start

Fits: VW Polo 6C (2014–2017)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove bench seat (see the separate procedure).
2. Remove backrest (see the separate procedure).
3. Release sill panel moulding from fasteners in sill at transition to side panel.
4. Remove side trim panel (see the separate procedure).
5. Removing lock carrier cover (see the separate procedure).

6. Removing side support for luggage compartment cover (see the separate procedure).
7. Remove roof end strip (see the separate procedure).
8. Removing C-pillar trims (2-door models) (see the separate procedure).
9. Remove bolt (1) (40 Nm) and remove belt guide fitting (2) from body. — 40 Nm (30 lb-ft)
10. Unscrew bolt (1) (40 Nm) and release belt inertia reel (2) from mounting. — 40 Nm (30 lb-ft)
11. Install in reverse order of removal.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing pre-wired wiring harness for unit injectors and glow plugs · 1 torque figures
• Removing and installing propshaft, CC 2012 ►, Passat 2011 ►, Passat Estate 2011 ►
• Removing and installing propshaft, Golf 2013 ►, Golf Estate 2014 ►
• Draining and filling gear oil
• Removing and installing dash panel fuse holder · 2 torque figures