Removing and installing rear light, vehicles 11.03 ▸: VW Sharan I / SEAT Alhambra

🧭 Before you start

Fits: VW Sharan I / SEAT Alhambra (7M)

📋 Procedure

1. Switch off ignition and all electrical consumers and remove ignition key.
2. Remove cover in luggage compartment trim.
3. Pull off connector (2).
4. Unclip interior light in luggage compartment trim.
5. Remove securing nuts (arrows) for rear light (1).

6. Unclip trim under rear light (arrow A).
7. Pull trim off to rear (arrow B).
8. Remove rear light (1) securing screw (2) and remove plastic clip (3) from side of light.
9. Tilt top of rear light (1) to rear (movement arrow).
10. Pull securing tab (2) to rear (arrow) and take rear light (1) out upwards.

🎬 Video walkthrough

Independent video tutorial by AUTODOC (YouTube) — a helpful visual companion to the steps above.

How to change rear light lamp bulbs on VW SHARAN 7M TUTORIAL

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing engine mountings · 7 torque figures
• Installing drive plate · 10 torque figures
• Removing, installing and tensioning toothed belt, engine code AWC · 5 torque figures
• Checking valve timing – VW Polo 6C · 7 torque figures
• Removing and installing front seat belts – VW Golf Cabriolet · 9 torque figures