Removing and installing pedal cluster — VW
Removing and installing pedal cluster on VW: 12 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Don't miss
- The upper hexagon nut for securing the pedal cluster is not visible in the diagram. It is on the front partition, behind crash anchor .
📋 Procedure
- Remove dash panel 90 and 97
- Removing driver's side cover. 68
- Remove heating blower. 80
- Remove bolts (1).
- Remove cover (2).
- Remove brake light switch by turning to left 45°.
- Disconnect throttle cable.
- Vehicles with throttle pedal position sender, release connector below dash panel.
- Separate brake pedal from brake servo .
- Remove hexagon nut (arrow). [Note: The upper hexagon nut for securing the pedal cluster is not visible in the diagram. It is on the front partition, behind crash anchor .]
- Remove pedal set.
- Adjust brake light switch .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Checking fuel gauge G sender (CAYA, CAYB, CAYC) – VW 1.6 TDI
- Assembly overview - brake booster/brake master cylinder, LHD vehicles with securing pin
- Removing and installing additional brake light M25
- Checking delivery rate of fuel system pressurisation pump G6, engine codes CBAA, CBAB, CBBB, CBDA, CBDB, CBDC, CJAA, CFFA, CFFB, CFGB, CFHB, CFHC, CLCA, CLJA
- Removing and installing rear side-airbag crash sensor, driver side G256
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.