Removing and installing park assist steering control unit J791, right-hand drive — VW

🧭 Before you start

Fits: VW Golf VI (5K, 2008–2013)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off ignition and all electrical consumers and remove ignition key.
2. Remove cover on side of dash panel General body repairs, interior68Compartments, covers and trims.
3. Remove trim panel in which light switch is installed General body repairs, interior68Compartments, covers and trim
4. Remove relay carrier .
5. Remove securing bolt (arrow) for park assist steering control unit above relay carrier.
6. Remove data bus diagnostic interface J533 (gateway) .
7. Release and disconnect the three connectors (arrows) and remove the park assist steering control unit J791(1) upwards out of bracket.
8. Tighten securing bolt of park assist steering control unit J791 to 1.5 Nm. — 1.5 Nm (1.1 lb-ft)

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Cylinder head - disassemble and assemble
• Servicing camshaft – VW BJR
• Repairing gearbox cover
• Checking intake manifold flap motor V157
• Renewing diesel direct injection system control unit J248