Removing and installing operating mechanism — VW
Removing and installing operating mechanism on VW: 14 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 5C7, 5C1
Don't miss
- Before closing rear lid, check function of lid release components.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 4 Nm (3.0 lb-ft) | Tighten bolts firmly |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove lower rear lid trim General body repairs, interior70Luggage compartment trims; Removing and installing lower rear lid trim.
- Remove rear lid trim General body repairs, interior70Luggage compartment trims; Removing and installing rear lid trim.
- Disconnect connector (1) from operating mechanism (2).
- If fitted, disconnect additional connectors for reversing camera R189 from operating mechanism (2).
- Remove bolts (3).
- Turn operating mechanism (2) in direction of (arrow a) until hook (4) behind profile (5) protrudes.
- Pull water drainage hose (6) off operating mechanism (2)(arrow b) and remove operating mechanism.
- Connect water drainage hose (6) to operating mechanism (2)(arrow a) and insert it into rear lid.
- Turn operating mechanism in (direction of arrow b) until hook (4) engages behind profile (5).
- Screw in bolts (3) and tighten them.
- Connect connector (1) to operating mechanism (2).
- If present, connect additional connectors for reversing camera R189 to operating mechanism (2). [Note: Before closing rear lid, check function of lid release components.]
- Install lower rear lid trim General body repairs, interior70Luggage compartment trims; Removing and installing lower rear lid trim.
- Install rear lid trim General body repairs, interior70Luggage compartment trims; Removing and installing rear lid trim.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing alternator C, vehicles with 1.2 l TSI engine
- Removing and installing alternator C, vehicles with diesel engine
- Rear axle in unladen position (four-wheel drive)
- Removing and installing high-voltage wiring harness for high-voltage battery PX1
- Removing and installing high-voltage battery charging socket 1 UX4, AC charging socket
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.