Removing and installing number plate lights, bolted fitting — VW
Removing and installing number plate lights, bolted fitting on VW: 5 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Jetta VI (16, 2010–2018)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Tighten screws |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical consumers, and remove ignition key.
- Remove bolts (arrows).
- Remove number plate light.
- Tighten screws to 2 Nm. — 2 Nm (1.5 lb-ft)
- Check function of number plate light.
🎬 Related video tutorial
Independent AUTODOC tutorial for the same job, filmed on a different model (PASSAT B6) — the technique carries over, the fasteners and figures on this page are the ones for your car.
How to change license plate light bulbs on VW PASSAT B6
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing side member trim – VW Jetta VI
- Removing and installing tunnel cross-piece – VW Passat B8
- Removing and installing sunroof panel – VW Passat B8
- Removing and installing starter, vehicles with 6-speed dual clutch gearbox 0D9, vehicles with 7-speed dual clutch gearbox 0DL
- Removing and installing washer fluid reservoir, washer fluid reservoir in front left wheel housing
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.