Removing and installing mounting for storage compartment, centre dash panel — VW

🧭 Before you start

Fits: platform codes 612, 614

• Renewed: if necessary

Don't miss

• Before installing, check all fasteners for damage and renew if necessary.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove dash panel middle trims .
2. Remove radio if there is one Communication91Radio units in general; Removing and installing radio unit and radio navigation system.
3. Remove heating control unit and air-conditioning unit Heating and air-conditioning system87Air-conditioning system with manual control; Removing and installing heating and air-conditioning control unit.
4. Remove operating and display unit for Climatronic air conditioning system E87 with Climatronic control unit J255Heater, air conditioning system87Air conditioning system with automatic regulation "“Climatronic”"; Removing and installing operating and display unit for Climatronic air conditioning system E87 with Climatronic control unit J255.
5. Remove dash panel compartment, centre .
6. Remove bolts (1) and (2) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
7. Release mounting bracket for storage compartment (1) from dash panel.
8. Install in reverse order of removal. [Note: Before installing, check all fasteners for damage and renew if necessary.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing, installing and checking suction-jet pumps – VW
• Checking tensioning roller for main drive – VW Golf V / Jetta
• Removing and installing selector lever knob
• Bleeding fuel system (engine codes BEV and BGD only)
• Removing and installing exhauster pump for brake servo