Removing and installing mounting bracket, left-hand drive: VW Golf Sportsvan

🧭 Before you start

Fits: VW Golf Sportsvan (AM1, 2014–2020)

📋 Procedure

1. Remove dash panel end cover on driver side General body repairs, interior70Dash panel; Removing and installing dash panel end cover.
2. Remove footwell cover on driver side General body repairs, interior68Compartments and covers.
3. Remove centre console trim in footwell on driver side General body repairs, interior68Centre console; Removing and installing centre console trim in front footwell.
4. Remove storage compartment on driver side General body repairs, interior68Compartments and covers.
5. Remove dash panel cover on driver side General body repairs, interior68Compartments and covers; Removing and installing dash panel cover on driver side.

6. Remove knee airbag (1)General body repairs, interior69Knee airbags; Assembly overview - knee airbag.
7. Remove footwell vent on driver side Heating, air conditioning system87Air duct; Assembly overview - air duct and air distribution in passenger compartment.
8. Unbolt crash bar for brake pedal and lay it to one side General body repairs, interior70Dash panel central tube; Assembly overview - dash panel central tube.
9. Unscrew bolt (2), detach crash bar (1), and push it to one side.
10. Remove headlight range control unit J431/control unit for cornering light and headlight range control J745(1), and lay it to one side Electrical system94Automatic headlight range control; Removing and installing headlight range control unit.
11. Separate brake pedal from brake servo .
12. Pull connector off accelerator pedal position sender.
13. Unscrew bolts (1) and fold footwell trim (2) in direction of arrow towards vehicle interior.
14. Unscrew nuts (1 to 4).
15. Carefully remove foot pedal cluster.
16. Connect brake pedal to brake servo .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing 2nd heat exchanger switch-off valve N317 · 2 torque figures
• Removing and installing oil pressure switch F1 – VW · 2 torque figures
• Removing and installing coolant temperature sender G62 – VW · 1 torque figures
• Removing and installing airbag unit on driver side, Sharan 2016►
• Removing and installing front seat backrest cover and padding