Removing and installing luggage compartment cover side cover — VW
Removing and installing luggage compartment cover side cover on VW: 7 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Remove bolts (arrows |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition.
- Release fasteners (1) from cover.
- Remove bolts (arrows) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
- Release upper part of cover (2) from fasteners in C-pillar.
- Pull cover off upwards and pull seat belt out through gap in cover.
- Separate any wiring harnesses.
- Install in reverse order of removal.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing fuel delivery unit – VW Passat B6 2.0
- Removing seal – VW Passat B6 1.6 BSE/BSF
- Installing seals
- Renewing spur gear for crankshaft, engine codes CBAA, CBAB, CBAC, CBBA, CBBB
- Removing and installing seals on assembly frame – VW
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.