Removing and installing lock carrier with assembling components — VW

🧭 Before you start

Don't miss

• Do not hang condenser by the pipes.Condenser pipes must be folded.

📋 Procedure

1. Removing radiator grille (see the separate procedure).
2. Removing bonnet lock (see the separate procedure).
3. Pull bowden cable out of lock and disconnect electric connectors.
4. Disconnect electric connectors from headlight casing.
5. Removing bumper and front bumper mounting (see the separate procedure).

6. Pull headlight cleaning system pipe out of distributor in T-piece.
7. Loosen radiator and condenser from bonnet lock carrier.
8. Fit radiator and condenser to engine compartment Insulation, air conditioning87 [Note: Do not hang condenser by the pipes. Condenser pipes must be folded.]
9. Center lock carrier on the beams and between wings.
10. Gap measures Body maintenance00.
11. Adjust headlights again.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing propshaft, Passat 2015 ►, Passat Variant 2015 ►
• Removing and installing selector mechanism without selector housing
• Filling gear oil in bevel box – VW CC · 1 torque figures
• Renewing seal for right flange shaft – VW · 1 torque figures
• Removing and installing centre console storage compartment · 2 torque figures