Removing and installing lock carrier trim: VW Touran II

🧭 Before you start

Fits: VW Touran II (5T, 2015–)

• Renewed: if necessary

📋 Procedure

1. Remove luggage compartment floor backwards (5-seater).
2. Remove luggage compartment floor upwards (7-seater).
3. Pull off rear lid seal (2) in area of lock carrier trim (1).
4. Release lock carrier trim (1) in area of retaining clips from body mountings (arrows) using removal lever80 - 200.
5. Remove lock carrier trim (1) upwards.

6. Remove luggage compartment floor backwards (5-seater).
7. Remove luggage compartment floor upwards (7-seater).
8. Release clip (3)
9. Pull off rear lid seal (2) in area of lock carrier trim (1).
10. Release lock carrier trim (1) in area of retaining clips from body mountings (arrows) using removal lever80 - 200.
11. Remove lock carrier trim (1) upwards. [Note: Before installing, check all fasteners for damage and renew if necessary.Remove any retaining clips left in body mountings using removal tool T40280 and fit them in lock carrier trim for installation.Following installation, ensure that the lock carrier trim is positioned in rear lid seal beading.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing bonded rubber bush – VW Polo 6R CLPA
• Removing and installing moulded headliner, 2-door models – VW · 1 torque figures
• Removing gearbox, Golf Cabriolet with 2.0 l diesel engine, engine lifting eyes fitted »diagonally« on engine
• Removing bevel box, CC 2012 ►, Passat 2011 ►, with diesel engine · 1 torque figures
• Removing and installing Valeo heat exchanger, RHD vehicles