Removing and installing load compartment side trim: VW CC
Step-by-step removing and installing load compartment side trim for the VW CC: 6 steps, 2 torque figures.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW CC (358, 2012–2017)
- Renewed: if necessary
Don't miss
- Before installing, check buttons for damage and renew if necessary.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Unscrew bolt (3 |
| 6 Nm (4.4 lb-ft) | Remove the two bolts (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove floor covering from vehicle.
- Remove lock carrier trim .
- Remove the two bolts (1) (6 Nm) and remove lashing eye (2). — 6 Nm (4.4 lb-ft)
- Unscrew bolt (3) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
- Using release tool T10236, remove the four buttons (arrows) and detach trim from mountings in vehicle.
- Install in reverse order of removal. [Note: Before installing, check buttons for damage and renew if necessary.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Aligning exhaust system stress free · 2 torque figures
- Dismantling and assembling output shaft for 1st and 2nd gear
- Removing and installing frame in moulded headliner – VW · 2 torque figures
- Removing Haldex coupling · 1 torque figures
- Removing and installing anti-theft engine control unit J623 (Golf)
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.