Removing and installing frame in moulded headliner: VW Golf V / Jetta / Golf VI

🧭 Before you start

Fits: VW Golf V / Jetta (1K, 2003–2009), VW Golf VI (5K, 2008–2013)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off ignition.
2. Remove front interior light W1, Electrical system96Lights and switches in roof trim.
3. Remove spectacles holder in moulded headlining .
4. Remove the two bolts (4) (2 Nm). — 2 Nm (1.5 lb-ft)
5. It is not necessary to remove sun visor (1), and grab handles (2) and (3).
6. In installation area of spectacles holder, remove 2 more bolts (2 Nm) and remove frame from mountings. — 2 Nm (1.5 lb-ft)
7. Install in reverse order of removal.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Installing airbag (retrofit kit) · 2 torque figures
• Steering column covering - remove and install · 3 torque figures
• Steering column - remove and install
• Gearbox - removal
• Renewing crankshaft oil seal, vibration damper end – VW · 3 torque figures