Removing and installing left engine support: VW Touareg II 6.0 (BAN, BAP, BRN, BRP, …)

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

🔧 Engine codes this applies to

📋 Procedure

1. Disconnect electrical connector (3) and remove bolt (1).
2. Release hose clips (2) and (5) and remove air pipes (left-side).
3. Remove bolt (1).
4. Release hose clip (arrow) and remove air pipe (left-side).
5. Support engine in its installation position .

6. Remove nut (arrow). Raise engine with threaded spindle until engine support (left-side) is positioned above stud of engine mounting (left-side).
7. Remove bolt (1) from right engine support and remove it.
8. Remove nut (arrow). Raise engine using workshop hoist via lifting eye on left-hand side until left-hand engine support is positioned above stud of left-hand engine mounting.
9. Remove bolt (1) from right engine support and remove it.
10. Unscrew bolts (1) for coolant and oil supply lines for turbocharger.
11. Unscrew bolts (arrows) and remove engine support on left.

Other VW procedures

• Removing and installing engine control units – VW Phaeton
• Parts of chain drive system - engine codes BRN, BRP and BTT
• Parts of chain drive system - engine codes BAN and BAP
• Assembly overview - cylinder bank 1 exhaust manifold with starter catalytic converters and attachments
• Assembly overview - cylinder bank 2 exhaust manifold with starter catalytic converters and attachments
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures