Removing and installing jump start point with suppression filter C24 — VW

🧭 Before you start

Fits: VW Golf V / Jetta (1K, 2003–2009)

📋 Procedure

1. Switch off ignition and all electrical consumers.
2. Disconnect battery .
3. Release retaining clip (arrow A) and open cover (1) above the positive terminal grip.
4. Release cover (2) above electrical wiring in direction of (arrow B).
5. Unscrew securing nuts (5) and (6) for positive lines.

6. Disconnect electrical connector (1) on suppression filter (4).
7. Unscrew bolt (3) and remove the positive terminal grip (2) with suppression filter from the bracket.
8. Tighten all threaded connections to specified torque .
9. Reconnect hose for degassing the battery on batteries with central gas venting.
10. Reconnect battery .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing gas discharge lamp L13/L14, headlights with gas discharge lamps and cornering lights
• Removing and installing trailer detector control unit
• Removing and installing tandem pump, engine codes AXD, AXE, BLJ, BNZ, BPC
• Renewing the paper filter on the vaporiser – VW 1.6 CHGA
• Checking SERTO adapter leads for leaks – VW 1.6 CHGA