Removing and installing gas discharge bulb L13/L14 — VW
Removing and installing gas discharge bulb L13/L14 on VW: 12 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 5C7, 5C1
📋 Procedure
- ⚠ Observe safety notes on gas discharge bulbs . — Switch off ignition and all electrical consumers, and remove ignition key.
- Remove headlight .
- Remove bolts (arrows).
- Pull off cover cap (2) from headlight (1).
- Press springs (arrows) together and withdraw gas discharge lamp (1) to rear out of headlight (2).
- Detach connector (3) from gas discharge lamp (1).
- ⚠ Do not touch bulb glass when installing a bulb. Fingers leave traces of grease on the glass, which evaporate when the bulb is switched on and cause the glass to cloud over.Do not expose glass of gas discharge lamp to mechanical stress of any kind. The glass bulb is extremely sensitive and is also under a high internal pressure.Do not look directly into the focused beam as the UV radiation from the gas discharge lamp is about 2.5 times higher than from normal halogen bulbs.Make sure cover cap is correctly seated when installing. The ingress of water will lead to permanent damage to the headlight. — Attach connector (3) to gas discharge lamp (1).
- Press springs (arrows) together and carefully fit gas discharge lamp (1) into lamp holder.
- Allow springs to engage.
- Install headlight .
- Check functions of headlight.
- Carry out basic setting of headlights .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing steering column (Polo saloon RUS) · 1 torque figures
- Removing and installing steering column, left-hand drive, vehicle with no knee airbag
- Checking valve timing, engine codes CPTA, CZEA – VW CPTA/CZEA · 1 torque figures
- Emptying fuel tank filled up to less then 3/4, vehicles with four-wheel drive
- Removing and installing control unit and hydraulic unit, left-hand drive, diesel engine
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.