Removing and installing front seat bar and operating lever — VW
Removing and installing front seat bar and operating lever on VW: 5 steps, 3 torque figures. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Jetta VI (16, 2010–2018)
- Renewed: if necessary
Don't miss
- Before installing, check all fasteners for damage and renew if necessary.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 7.5 Nm (5.5 lb-ft) | Unscrew bolts (3) and (5 |
| 7.5 Nm (5.5 lb-ft) | Unscrew two bolts (1 |
| 8 Nm (5.9 lb-ft) | Undo bolts (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove left trim on seat with manually adjustable seat height .
- Remove bolts (1).
- Remove operating lever (2) from seat frame.
- Remove bolts (1).
- Remove seat bar (2) from seat frame. [Note: Before installing, check all fasteners for damage and renew if necessary.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Checking brake light switch and brake pedal switch
- Checking fuel pump(s) – VW PG
- Dismantling and assembling selector mechanism on vehicles without key withdrawal lock up to 06.99
- Checking Lambda probe heating before catalyst
- Pressing front wheel bearing out and in with wheel bearing housing installed, 13" running gear
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.