Removing and installing bar and operating lever on seat with electrically adjustable backrest (USA) — VW

🧭 Before you start

Fits: VW Golf V / Jetta (1K, 2003–2009); platform code AJ5

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove right trim on seat with electrically adjustable backrest .
2. Remove the two bolts (4) (3.5 Nm) and remove operating lever (3). — 3.5 Nm (2.6 lb-ft)
3. Remove the two bolts (2) (3.5 Nm) and remove bar (1). — 3.5 Nm (2.6 lb-ft)
4. Install in reverse order of removal.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing gearbox mountings – VW Phaeton
• Renewing wiper motorV
• Removing and installing radioR · 1 torque figures
• Removing and installing refrigerant shut-off valve for heater and air conditioner unit N541
• Removing and installing brake caliper, FS III front brake – VW