Removing and installing front fog light (vehicles 10.00 ▸) — VW
Removing and installing front fog light (vehicles 10.00 ▸) on VW: 6 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B5 (3B)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | First tighten bolt (1) to a torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical consumers and pull out ignition key.
- To enable removal of the fog light, unclip cover (arrow) in bottom bumper section from centre of vehicle.
- Remove securing bolts (arrows).
- Pull fog light housing out of bumper and disconnect connector.
- First tighten bolt (1) to a torque of 1.5 Nm, then (2) and then (3). — 1.5 Nm (1.1 lb-ft)
- Check the headlight setting and adjust if necessary 36.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Renewing oil seal for selector shaft – VW 2.0
- Removing and installing poly V-belt pulley – VW CC CKMA/CTHD · 1 torque figures
- Removing and installing centre console front storage compartment · 1 torque figures
- Removing and installing one-piece rear seat backrest – VW CC · 1 torque figures
- Calibrating lane change assist
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.