TorqFix

Removing and installing frame: VW Sharan II / SEAT Alhambra

Step-by-step removing and installing frame for the VW Sharan II / SEAT Alhambra: 5 steps, 1 torque figure.

Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.

5 steps 1 torque figure torque figures merged from 2 documented variants

🧭 Before you start

Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

TorqueFastener / step
1 Nm (0.7 lb-ft)Unscrew bolts (3), specified torque

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

  1. Remove mirror glass .
  2. Remove bolts (3).
  3. Release locking hooks (arrows).
  4. Pull frame (1) off mirror housing (2).
  5. Unscrew bolts (3), specified torque: 1 Nm. — 1 Nm (0.7 lb-ft)

Other VW procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.