Removing and installing footwell cover: VW Sharan II / SEAT Alhambra

🧭 Before you start

Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off ignition.
2. Remove bolts (1) and (3) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
3. Unclip footwell cover (2) and remove downwards (arrow).
4. Pull footwell cover out of mountings above pedal cluster in direction of driver's seat.
5. Detach connector from footwell light.
6. Unclip diagnostic connector from footwell cover.
7. Install in reverse order of removal.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing frequency switch – VW Golf V / Jetta · 1 torque figures
• Checking vane pump delivery pressure, 5-cylinder petrol engine
• Removing and installing trim panel on glove compartment – VW · 1 torque figures
• Removing and installing rear trim bracket of »Comfort and Highline« centre console · 1 torque figures
• Removing and installing middle securing bracket – VW Jetta VI · 1 torque figures