Removing and installing rear trim bracket of »Comfort and Highline« centre console — VW
Removing and installing rear trim bracket of »Comfort and Highline« centre console on VW: 4 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Jetta VI (16, 2010–2018); platform code AV2
- Renewed: if necessary
Don't miss
- Before installing, check all fasteners for damage and renew if necessary.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Remove 2 bolts (2) from bracket (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Removing rear trim of »Comfort and Highline« centre console
- Remove 2 bolts (2) from bracket (1) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
- Remove bracket (1) from centre console.
- Install in reverse order of removal. [Note: Before installing, check all fasteners for damage and renew if necessary.]
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.