Removing and installing floor covering: VW Golf Sportsvan

🧭 Before you start

Fits: VW Golf Sportsvan (AM1, 2014–2020)

Don't miss

• Ensure that the floor covering is not torn in the area of the cut-outs. — Fold front floor covering, and remove it through front door aperture.

📋 Procedure

1. Remove front seats .
2. Remove rear seats .
3. Remove sill panel mouldings .
4. Remove lower A-pillar trims .
5. Remove front belt end fittings .

6. Remove centre console .
7. Remove foot rest .
8. If fitted, remove rear air duct Heating, air conditioning87Air duct; Assembly overview - air duct and air distribution in passenger compartment.
9. Remove floor mats (1 and 2).
10. Lift front floor covering (3) at rear, and pull it towards rear.
11. ⚠ Ensure that the floor covering is not torn in the area of the cut-outs. — Fold front floor covering, and remove it through front door aperture.
12. Remove rear seats .
13. Remove wheel housing trim .
14. If fitted, remove luggage compartment floor covering bracket .
15. Remove clips (3) for luggage compartment floor covering.
16. Pull out rear floor covering (1) from underneath luggage compartment floor covering (4).
17. Pull out rear floor covering (1) from underneath front floor covering (2).
18. Fold rear floor covering, and remove it through rear door aperture.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing door · 8 torque figures
• Removing and installing defroster flap control motor V107 · 9 torque figures
• Removing and installing turbocharger 1 control unit J724 · 6 torque figures
• Pressing sealing flange with sender wheel onto crankshaft · 6 torque figures
• Renewing crankshaft sealing flange -flywheel end- · 5 torque figures