Removing and installing ESP sensor unit G419: VW Golf V / Jetta

🧭 Before you start

Fits: VW Golf V / Jetta (1K, 2003–2009); platform codes 5M1, 1F7

Don't miss

• Do not use the securing nuts to forcibly position the ESP sensor unit G419.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. ⚠ Severe shocks (e.g. dropping, impact) may destroy the ESP sensor unit G419. The ESP sensor unit G419 may not then be used any further. — Remove right front seat together with seat frame General body repairs, interior72.
2. Remove sill panel trim General body repairs, interior68Sill panel trims.
3. Lift carpet and lay to the side.
4. Remove coupling station (1).
5. Raise floor covering.

6. Pull connector (1) off ESP sensor unit G419.
7. Remove the two securing nuts (arrows).
8. Remove ESP sensor unit G419.
9. Install in reverse order. [Note: Do not use the securing nuts to forcibly position the ESP sensor unit G419.]
10. Tighten securing nuts to 9 Nm. — 9 Nm (6.6 lb-ft)
11. Perform basic setting of lateral acceleration sender G200.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Tailgate - adjust · 2 torque figures
• Front door lock - remove and install · 2 torque figures
• Assembly sequence - bevel gear mounting · 1 torque figures
• VW Polo4 1.2 AWY/BMD cylinder head removal & torque
• Tilting window - adjust · 3 torque figures