Removing and installing engine cover with air cleaner — VW
Removing and installing engine cover with air cleaner on VW: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
📋 Procedure
- Unclip air intake hose on the upper part and on the side of the air ducting (arrows).
- Pull vacuum line (1) off the actuator for intake air preheating.
- Disconnect electrical connection (2) on intake air temperature sender 2G299.
- Pull oil dipstick (1) out.
- Pull engine cover off on the marked points (arrows).
- Fit the oil dipstick (1) again into guide tube to limit stop.
- Pull oil dipstick out of guide tube.
- Fit the rubber mountings of the cover on the pins fitted on the engine.
- Pull cover downwards on the marked points (arrows).
- Fit the oil dipstick (1) again into guide tube to limit stop.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing valve blocks for R36 leather sport seat – VW
- Removing and installing front exhaust pipes with catalytic converters and front silencers (vehicles with front-wheel drive)
- Installing gearbox - vehicles with 3.6 l - 206 kW engine – VW
- Installing gearbox - vehicles with 2.0 l - 103 kW TDI engine
- Removing injectors – VW 2.0 TDI
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.