Removing and installing engine control unit J623, Sharan — VW
Removing and installing engine control unit J623, Sharan on VW: 15 steps, engines CHHA, CHHB, CJSA, CJSB.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)
📋 Procedure
- If the engine control unit is to be renewed, switch on ignition, and select the following menu options on vehicle diagnostic tester:
- Switch off ignition and remove ignition key.
- Remove wiper arms Electrical system92Windscreen wiper system; Removing and installing wiper arms.
- Remove plenum chamber cover General body repairs, exterior50Plenum chamber bulkhead; Assembly overview - plenum chamber cover.
- Remove plenum chamber bulkhead General body repairs, exterior50Bulkhead; Assembly overview - bulkhead.
- Pull seal together with engine wiring harness upwards in (direction of arrow) out of cable guide.
- If fitted, unclip cover (1) at sides from mountings (1)(arrows), and remove it.
- Push guides (2) outwards.
- Remove engine control unit (1) upwards.
- Slide connector locking devices (1) on engine control unit in (direction of arrow) and pull off both connectors.
- Attach connectors to engine control unit and slide locking devices inwards until they engage.
- Push engine control unit (1) into side guides (2) in the (direction of arrow).
- Install plenum chamber bulkhead General body repairs, exterior50Bulkhead; Assembly overview - bulkhead.
- Install plenum chamber cover General body repairs, exterior50Plenum chamber bulkhead; Assembly overview - plenum chamber cover.
- Fit wiper arms Electrical system92Windscreen wiper system; Removing and installing wiper arms.
Other VW procedures
- Removing and installing radiator, Golf, Passat
- Removing and installing left auxiliary radiator
- Removing and installing coolant temperature sender at radiator outlet G83
- Cleaning injectors – VW Golf Cabriolet
- Removing and installing oil pressure regulating valve N428
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.