Removing and installing easy-entry Bowden cable A — VW

🧭 Before you start

Fits: platform code 138

Don't miss

• Make sure that backrest is in basic position, i.e. backrest must be turned to front stop using adjuster knob. — First, attach »Easy-Entry« Bowden cable A (1) to seat longitudinal adjuster (2).

📋 Procedure

1. Remove front seat .
2. Remove seat trim on tunnel side .
3. Turn backrest to front stop using adjuster knob.
4. Unclip support bracket of »Easy-Entry« Bowden cable A (1) from seat longitudinal adjuster (2).
5. Detach »easy-entry« Bowden cable A (1) at seat longitudinal adjustment (2) and remove.

6. Detach »Easy-Entry« Bowden cable A (1) from backrest fitting.
7. Pull guide of »Easy-Entry« Bowden cable A (2) off seat frame.
8. ⚠ Make sure that backrest is in basic position, i.e. backrest must be turned to front stop using adjuster knob. — First, attach »Easy-Entry« Bowden cable A (1) to seat longitudinal adjuster (2).
9. Clip support bracket of »Easy-Entry« Bowden cable A (1) to seat longitudinal adjuster (2).
10. Attach »Easy-Entry« Bowden cable A (1) to backrest fitting.
11. Fit guide of »Easy-Entry« Bowden cable A (2) onto seat frame.
12. Adjust »Easy-Entry« Bowden cable A .
13. Lock »Easy-Entry« Bowden cable A (1) with clip (2).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking overrun boost
• Fitting instructions for exchange engines – VW ACD/AS
• Gearbox: Electrical check
• Removing and installing transverse link
• Dismantling planet gearbox