Removing and installing driver side deformation element: VW Touareg II
Step-by-step removing and installing driver side deformation element for the VW Touareg II: 7 steps, 2 torque figures.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touareg II (7P, 2010–2018)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Remove 2 bolts (1) and (2 |
| 1.5 Nm (1.1 lb-ft) | Unscrew bolts (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove side dash panel cover on driver side .
- Remove left dash panel trim, driver side .
- Remove floor covering, driver side .
- Remove right dash panel trim, driver side .
- Remove 2 bolts (1) and (2) (1.5 Nm) in each case. — 1.5 Nm (1.1 lb-ft)
- Pull deformation element (3) off dash panel.
- Install in reverse order of removal.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing brake caliper piston, floating caliper disc brake 2FNR
- Removing and installing suspension strut, suspension strut secured with bolts
- Dismantling and assembling drive shaft, constant velocity joint VL4700
- Removing and installing drive shaft, right drive shaft
- Checking low pressure on high-pressure pump, engines with supplementary fuel pump V393
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.