Removing and installing drive for rear lid: VW Touran II

🧭 Before you start

Fits: VW Touran II (5T, 2015–)

📋 Procedure

1. Detach D-pillar trim General body repairs, interior70Trims, interior; Removing and installing D-pillar trim.
2. Separate electrical connectors for wires of rear lid drive (1) on inside of D-pillar.
3. Pull out wires with rubber grommet (6).
4. Support rear lid.
5. Push drive towards ball-head pin.

6. Insert a small screwdriver (3) under spring clips (2)(arrows a).
7. Raise spring clips (2) until spring clips can be moved over ball sockets.
8. Pull off rear lid drive (1) from ball-head pins (4)(arrows b).
9. Push drive (1) with ball sockets onto ball studs (6)(arrows b) until they engage audibly.
10. Route wiring with rubber grommet (2) and push in rubber grommet firmly (arrow a).
11. Join electrical connectors for wires of rear lid drive (3).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing lower part of reservoir for windscreen and headlight washer systems
• Removing and installing ► 10.2009 – VW Passat CC / CC
• Removing and installing starter, vehicles with 1.8 l, 118 kW TSI engine with manual gearbox MQ200-6F
• Removing and installing starter, 2.5 l, 125 kW injection engine, manual gearbox MQ250-5F
• Removing and installing starter, 1.4 l, 90 kW TSI engine with dual clutch gearbox (DSG) DQ200-7F