Removing and installing door trim cover — VW

🧭 Before you start

Fits: platform code 137

• Renewed: if necessary

Don't miss

• Before installing, check fasteners for damage and renew if necessary.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off ignition.
2. Remove door trim .
3. Fold up insulation in area of bolt and remove bolt (1) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
4. Pull off cover (1). [Note: Before installing, check fasteners for damage and renew if necessary.]
5. Install in reverse order of removal.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing gearbox; Passat 2006 ► 1.8 l - 112 and 118 kW - petrol engine
• Torque settings »Gearbox to engine« and notes on assembly mounting · 3 torque figures
• Checking fuel pump non-return valves – VW Touareg I
• Removing and installing camshaft drive timing chain, vehicles with vacuum pump · 2 torque figures
• Removing and installing tandem pump and fuel pump – VW 4.9 TDI · 2 torque figures