Removing and installing dash panel insert, as of model year 2010 — VW

🧭 Before you start

Fits: VW Golf V / Jetta (1K, 2003–2009); platform code AJ5

Don't miss

• There is no need to remove the steering wheel.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off ignition and all electrical consumers, and remove ignition key. [Note: There is no need to remove the steering wheel.]
2. Pull steering wheel fully out and lock it in lowest position.
3. Remove upper part of steering column trim General body repairs, interior68Compartments, covers and trim; Removing and installing steering column trim.
4. Remove bolts (arrows).
5. Pull dash panel insert backwards straight out of dash panel, taking connected wiring length into consideration.
6. Pull retaining clip (1) in (direction of arrow) and detach connector (2).
7. Remove dash panel insert from vehicle.
8. Tighten bolted connections to 1.5 Nm. — 1.5 Nm (1.1 lb-ft)

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing height adjustment motor
• Adjusting bonnet and striker pin · 2 torque figures
• Removing and installing lines for clutch mechanism – VW 2.0
• Removing and installing clutch pedal with over-centre spring, LHD
• Removing and installing drive shaft, constant velocity joint, threaded connection · 1 torque figures