Removing and installing coolant distributor housing with thermostat — VW

🧭 Before you start

Fits: VW Passat B6 (3C, 2005–2010); platform code 1F7

• Renewed: o-ring

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove alternator Electrical system27Alternator.
2. Remove coolant pipes .
3. Pull coolant hose (2) off coolant distributor housing by pulling out retaining clip (1).
4. Unscrew bolts (arrows) and remove coolant distribution housing with thermostat from engine.
5. Clean sealing surface for O-ring.
6. Renew O-ring and moisten it with coolant.
7. Fit coolant distributor housing on cylinder block and tighten bolts evenly to 15 Nm. — 15 Nm (11 lb-ft)
8. Further assembly is basically the reverse of the dismantling sequence.

Other VW procedures

• Renewing Teflon seal on injector
• Balance shaft assembly with oil pump - exploded view · 1 torque figures
• Removing and installing engine cover panel with air filter element
• Removing and installing intake manifold flap motor V157 and intake manifold flap potentiometer G336
• Removing and installing engine control unit without theft protection
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures