Removing and installing clutch actuatorVX64 with gearbox installed — VW
Removing and installing clutch actuatorVX64 with gearbox installed on VW: 15 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 121
Don't miss
- Do not open clutch actuatorVX64, risk of injury! — Disconnect electrical connector (arrow).
- Slightly pull on connector to ensure it is properly engaged.
📋 Procedure
- ⚠ Do not open clutch actuatorVX64, risk of injury! — Disconnect electrical connector (arrow).
- To disconnect, pull latch (1) towards cable and push catch (2) to side.
- Unscrew securing bolt (1).
- Unscrew securing bolt (2).
- Loosen securing bolt (3).
- Unscrew securing bolt (3) and remove clutch actuator.
- Insert plunger into clutch release lever.
- Push clutch actuator to stop of elongated hole and screw in securing bolt (3) hand-tight.
- Screw in securing bolt (2) hand-tight.
- Screw in securing bolt (1) hand-tight.
- Tighten all securing bolts to specified torque.
- Connect connector as follows:
- Push latch (1) towards clutch actuator.
- Slightly pull on connector to ensure it is properly engaged.
- Perform Basic Setting using Guided Functions in vehicle diagnostic tester
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing alternator, 1.6 l FSI engine – VW
- Removing and installing alternator, 3.6 l FSI engine and 3.2 l injection engine
- Installing fuel delivery unit – VW Passat B6 2.0 · 1 torque figures
- Removing and installing alternator, 2.0 l, 81 kW or 103 kW TDI engine
- Removing and installing engine bracket, Golf, Golf Cabriolet, Passat
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.