Removing and installing catalytic converter (Polo) — VW

🧭 Before you start

Fits: VW Polo 6R (2009–2014)

🔧 Engine codes this applies to

📐 60 workshop diagrams for CAVA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove Lambda probe G39(1) using Lambda probe open ring spanner set3337.
2. Unscrew upper securing bolt from alternator (2).
3. Then, press alternator down slightly.
4. Unbolt oil supply pipe from turbocharger and from oil filter housing .
5. Undo bolts (arrows) and remove heat shield from turbocharger.

6. Unscrew securing nuts on turbocharger (arrows).
7. Remove noise insulation General body repairs, exterior50Removing and installing noise insulation.
8. Disconnect connector (1).
9. Remove Lambda probe after catalytic converter G130(2).
10. Unscrew securing bolts (1).
11. Press support rings (2) off bolts.
12. Loosen bolts of clamping sleeve (arrows) and push clamping sleeve backwards.
13. Remove catalytic converter together with exhaust pipe downwards.

Other VW procedures

• Removing and installing timing chain and drive chain for oil pump · 6 torque figures
• Checking timing chain – VW Jetta VI · 5 torque figures
• Removing and installing engine mountings · 7 torque figures
• Pressing sealing flange with sender wheel onto crankshaft · 6 torque figures
• Renewing vacuum unit for turbocharger · 3 torque figures
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures