TorqFix

Removing and installing bracket for charging unit 1 for high-voltage batteryAX4 — VW

Removing and installing bracket for charging unit 1 for high-voltage batteryAX4 on VW: 10 steps, engines CUKB, CUKC.

Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.

10 steps 2 engine codes engine codes merged from 4 documented variants

🧭 Before you start

Fits: VW Golf VII (5G, 2012–2020)

🔧 Engine codes this applies to

CUKBCUKC

📋 Procedure

  1. Remove charging unit for high-voltage battery .
  2. Remove two electrical wiring retainers from top of bracket.
  3. Remove high-voltage wire for electrical air conditioner compressor P3 from bracket.
  4. Remove coolant line from retainer on bracket.
  5. Unclip guide for high-voltage cable (2) from bracket (1).
CUKB? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove electrical connector (5) from bracket (1).
  2. Remove retainer (4) for electrical wiring from bracket (1).
  3. Remove nut (3).
  4. Remove bolts (arrows).
  5. Remove bracket (1).

Other VW procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.